CommScope ATC300-2000 - Manual (Page 96)

Section 9–Uploading Controller Firmware Using the IP Config Tool ATC300-1000/2000 Teletilt ® RET System
9-8 August 2014 Bulletin 639544 • Revision L
Figure 9-7. Files Ready For Upload To The Controller Shown.
2. Click on Upload.
1. Click on file to be uploaded.
9.4 Uploading Firmware Files to the Controller
1. Click on the firmware file that is to be uploaded (Figure 9-7). Only one file can be uploaded at a
time.
Note: Updates to the antenna definition file (*AT*.ascu) are recognized by the controller as soon as
the upload is complete. Updates to the controller’s software require that the controller be rebooted
(Figure 9-10) for the updates to be recognized.
2. Click on the Upload button (Figure 9-7).