CommScope ATC300-2000 - Manual (Page 82)

ATC300-1000/2000 Teletilt ® RET System Section 8–Configuring the Controller to Connect Over an SNMP Manager
Bulletin 639544 • Revision L August 2014 8-L
8.2.1 Site Sharing Configuration
ATC300 software release 2.36 provides the capability for site sharing. A logged in administrator
must enable and configure the operator usernames and passwords, scan the AISG bus for devices,
and assign operators to each device. Operators are limited in their privileges, and are permitted to
only view and manage the AISG devices to which they have been assigned.
When the administrator is logged in, two new buttons are available, Manage Operators and Assign
Operators to Devices (see Figure 8-5 Controller Configuration Options for Site Sharing Admin-
istrator). These two features are covered in the next sections. In addition, the menu displays an
option to Logout. This menu item is available to all logged-in operators as well.
Figure 8-5 Controller Configuration Options for Site Sharing Administrator
8.2.1.1 Operator Name and Password Management
The administrator may create up to four operator names and passwords (see Figure 8-6 Operator
Management Web Page). These can later be assigned to AISG devices that have been found on
the bus.
Note that when an operator name is modified, any AISG devices assigned with that operator name
will be unassigned. That is, the administrator must revisit the Assign Operators to Devices web
page and reassign those devices with operator names.
The controller maintains alarm history logs specifically for each operator, containing alarm logs for