CommScope ATC300-2000 - Manual (Page 42)

ATC300-1000/2000 Teletilt ® RET System Section 3–Changing IP Settings on the Local PC Using the IP Config Tool
Bulletin 639544 • Revision L August 2014 3-9
3.7 Restoring Backup Files for New IP Settings on the Local Computer
for Regaining Access to the Controller
After a local computer has been set up with a new IP address using the Andrew IP Config Tool, the
backup file that was saved during the initial set up can be used to restore the settings and regain ac-
cess to the controller (See paragraph 3.5).
1. If the IP Config Tool is not already launched, double-click the Andrew IP Config Tool icon from
the local computer’s desktop to launch (Figure 3-2).
2. Click on the backup file shown in the window (Figure 3-9).
3. Click on the Restore button (Figure 3-9).
Leave the Andrew IP Configuration Tool running until access to the controller is no longer needed. See
Section 6 for accessing the controller using a direct Ethernet connection.
Figure 3-9. Restoring Backup File Settings To Regain Access To Controller.
1. Select the backup file.
2. Click on Restore.
3. Backup IP settings are restored
to local computer.