CommScope ATC300-2000 - Manual (Page 59)

Section 5–Obtaining IP Settings for Controller (When IP is Unknown) ATC300-1000/2000 Teletilt ® RET System
5-10 August 2014 Bulletin 639544 • Revision L
5.2.2 Configuring the Serial Connection
A Login screen will appear upon exiting the New Connection Wizard.
1. Leave all fields blank in the Login screen, and click on Properties (Screen 1, Figure
5-16).
2. Select Communications cable between two computer (COM1) from the drop down menu if it
is not the default that appears.
3. Place a check mark in the box next to Show icon . . ., and click on Configure (Screen 2, Figure
5-16).
Figure 5-16. Configuring Serial Connection (Screens 1 through 2).
2. Click.
1. Clear all fields.
1
2. Click.
1. Select.
2