CommScope ATC300-2000 - Manual (Page 163)

Section 19–Adjusting Electrical Downtilt-Single SmartBeam ® Antenna ATC300-1000/2000 Teletilt ® RET System
19-2 August 2014 Bulletin 639544 • Revision L
The Tilt Axis Movement screen shown in Figure 19-2 displays the information that was previously
configured for the device. This information may be used as a reference to help determine the new tilt
setting. Note that only tilt changes may be made from this screen. Any changes needed to be made
to the configuration for the device must be done from the Device Configuration screen as discussed
in Section 12.
3. Enter the new angle for the device in the New Tilt field. Note that the allowed range of angle values
is displayed in the Min Electrical Tilt and Max Electrical Tilt fields in the top part of the screen.
Any downtilt angle within this range may be entered. Angles may be entered as whole degrees,
or as a combination of whole degrees and tenths of a degree (Figure 19-2).
Examples: Five degrees downtilt may be entered as 5 or 5.0. A downtilt of five and one-half de-
grees would be entered as 5.5.
4. Click on Set Tilt to apply the changes to the electrical downtilt for this antenna. Alternately, to exit
the screen without sending any changes, click on Close.
Figure 19-2. Changing Electrical Tilt Setting For Single Antenna.
1. Review the electrical tilt range to verify that the new tilt angle will be valid for the
antenna
model.
2. Enter the new electrical tilt angle.
Angles may be entered as whole degrees or as
a combination of whole degrees and tenths of a
degree (Ex: 5.0 or 5.5).
3. Click on Set Tilt.