CommScope ATC300-2000 - Manual (Page 176)

ATC300-1000/2000 Teletilt ® RET System Section 22– Adjusting Electrical Downtilt, Pan, Fan-Group SmartBeam ® Antennas
Bulletin 639544 • Revision L August 2014 22-3
2. Click on Close.
Current tilt angle shows
the new tilt setting.
Figure 22-3. Changing Electrical Tilt Setting For Antennas In Sector Move.
Figure 22-4. Tilt Change Is Complete For Sector Move.
2. Enter the new electrical tilt angle.
Angles may be entered as whole degrees or as a
combination of whole degrees and tenths of a degree
(Ex: 5.0 or 5.5).
1. Review the electrical tilt range to verify that the new tilt angle will be
valid for the antenna model.
3. Click on Set Tilt.
1. Click on Close
Window.