CommScope ATC300-2000 - Manual (Page 161)

Section 18–Device Configuration with SmartBeam ® Antennas ATC300-1000/2000 Teletilt ® RET System
18-4 August 2014 Bulletin 639544 • Revision L
6. Click on Close after the new settings have finished uploading to the device (Figure 18-3).
7. If the device was successfully configured, the status will indicate the device is OK on the main
screen. Note that not all of the items that were configured are displayed on the main screen (Figure
18-4).
To verify that each item configured was set correctly, select the device from the main screen and
click on Edit Selected to review each item. Click on Close when finished verifying the settings to
return to the controller’s main interface screen.
Figure 18-4. Configuration For New Device Displayed In Controller’s Main Interface Screen.
18.2 Saving a Device Configuration to File
To save your configurations to a file for future reference, place your mouse over the area where the
devices are listed on the main screen and right click. From the pop-up menu, select Export to
Microsoft Excel.
Click on Edit Selected.
New configuration settings are displayed and status indicates that
the device is OK, when it has been configured successfully
.