CommScope ATC300-2000 - Manual (Page 77)

7-6 August 2014 Bulletin 639544 • Revision L
Section 7–Changing the Controller’s IP Settings for Access Over a Network ATC300-1000/2000 Teletilt ® RET
7.2 Accessing the Controller Over the Network Connection
1. Connect the controller to the company’s LAN at the base station using an Ethernet cable, not
supplied.
2. From a computer connected to the same network, open an Internet browser (Netscape and
Mozilla browsers are not supported).
• If configured for Static IP, type the controller’s new network configured IP address into the
URL address window, and click on Go.
• If configured for DHCP ( ACT300-1000/2000 only ), type the controller’s hostname into the
URL address window, and click on Go.
Figure 7-7. Controller Access Using DHCP Over a Network.
6. The controller’s web interface returns to the main interface window (Figure 7-7).