CommScope ATC300-2000 - Manual (Page 193)

Appendix B–IP Addressing ATC300-1000/2000 Teletilt ® RET System
B-2 August 2014 Bulletin 639544 • Revision L
in Figure B-2.
Notes:
• Generally, the IP address is temporarily changed on the computer to be compatible with the con-
troller for initial setup. The IP settings are then changed on the controller to match the network
it will be accessed/operated through. See Sections 3 and 4 for changing the IP settings on the
local computer, and Section 7 for changing the IP settings on the controller.
• The Default Router is another IP setting, which provides a gateway for the controller to operate
over a network. The Default Router setting can be disregarded if the controller will not be us-
ing a network. Contact the network administrator for assistance in changing the IP settings for
Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
B.2 Setting An IP Address Using Windows Vista
The following procedure will show you how to change your IP Address if operating a Windows Vista
computer, so you can network with the ATC200/300 controller.
This procedure will only work on controllers that are still set up with the default IP Address
192.168.255.141; Subnet Mask 255.255.255.0. If your default address has been changed, consult
your operations manual for procedure to reset the default IP address.
From your desktop you are going to select 1. Start
→
Control Panel (Figure B-3).
Figure B-3. Selecting Control Panel.