CommScope ATC300-2000 - Manual (Page 146)

ATC300-1000/2000 Teletilt ® RET System Section 15–Device Configuration-Multiple Integrated Actuators
Bulletin 639544 • Revision L August 2014 15-3
• The ID for the base station associated with this antenna must be 1 to 12 characters
in length for AISG 1.x devices and 1-32 characters in length for AISG 2.0 devices, and may
contain any combination of numbers and letters.
• The Installation Date field must be 1 to 6 characters in length with any combination of
letters and numbers.
• The Installer ID must be 1 to 5 characters in length with any combination of letters
and numbers.
• The Location field is a string with a numeric value from 1 to 32 that describes an
actuator’s position within a sector. Each device should have a unique sector-location
combination.
• Mechanical tilt has a valid range of -12.8 to 12.7 in AISG 1.1, and ±180.0 in AISG 2.0.
• Values specified for the Frequency Band, Technology, and Mechanical Tilt are used for
reference only and have no direct affect upon the actuator/antenna that is being configured.
5. Carefully review all selections. If satisfied that all are correct, click on Set Device Data.
Alternately, the user may go back and edit/change any of the selections made or click on
Close to quit this process without making any changes to the actuator’s current configuration.
6. Click on Close after the new settings have finished uploading to the device (Figure 15-3).
Figure 15-3. Device Configurations Complete.
Click on Close.