CommScope ATC300-2000 - Manual (Page 168)

ATC300-1000/2000 Teletilt ® RET System Section 20–Adjusting Pan-Single SmartBeam ® Antenna
Bulletin 639544 • Revision L August 2014 20-3
5. A progress indicator bar will appear in a pop-up window to continually provide an update for as
long as the move is in progress. You will be notified when movement is complete. Click on Close
Window from the pop-up window (Figure 20-3).
If for any reason the move failed to reach the new az offset specified, you will be notified of the
failure.
6. After the antenna has completed movement to its new az offset, the new value will be displayed
in the Current Az Offset field and the New Az Offset will be cleared in preparation for the next
move (Figure 20-3).
At this point, you may click on Close (Figure 20-3) to return to the controller’s main interface screen
(Figure 20-4). Alternately, this process may be repeated to further adjust the downtilt or to reapply
changes where movement had previously failed, such as a temporary mechanical jam.
Figure 20-3. Tilt Change Complete For Single Antenna Move.
2. Click on Close.
Current Az Offset shows the
new Az Offset setting.
1. Click on
Close Window.