CommScope ATC300-2000 - Manual (Page 200)

ATC300-1000/2000 Teletilt ® RET System Appendix C–Uploading Firmware Manually
Bulletin 639544 • Revision L August 2014 C-3
1. Create a new user named anonymous.
Enable the Apply IP Rules and activate
the Read and List rights, deactivating all
other settings as shown in Figure C-1.
8. Click on the Home Directory browse el-
lipses to navigate to the ATC200 directory
(Figure C-1).
9. Click on OK (Figure C-1). You should now
see an icon for the new user in the User
Setup dialog box display area.
10. Click on Close.
Check the
Apply IP
Rules,
Read,
and List-
Boxes.
Click on OK.
Figure C-1. Add New User Dialog Settings for FTP Server.
11. Go to File → Start (or double-click on the FTP Server icon from the desktop) to launch the FTP
server. A line of text with the current time and date stating FTP Server started should be displayed
(Figure C-2).
12. Minimize the dialog box (do not close/exit!). The FTP server is now ready to transfer files to an
ATC200-1000 or ATC300-1000/2000 controller.
Note that if the ArGoSoft software is unregistered, the FTP server session will disconnect in 120
minutes. You can correct this by re-enabling it manually or shutting it down and restarting it.
Figure C-2. FTP Server Activated.
Restart Button.