CommScope ATC300-2000 - Manual (Page 134)

Bulletin 639544 • Revision L August 2014 13-1
Section 13
Adjusting the Electrical Downtilt on a Single
Antenna
13.0 Section Overview
• The electrical downtilt may be adjusted on any device that is addressed, configured, and whose
current state does not prevent antenna movement.
• Movement may be prevented when a device is not responding to commands from the controller, is
in the middle of a move or configuration change, or is experiencing a mechanical malfunction.
13.1 Adjusting the Downtilt Angle on a Single Antenna
1. From the controller’s main interface screen, select the device to be moved (Figure 13-1).
2. Click on Move Selected (Figure 13-1).
Figure 13-1. Selecting Device To Be Adjusted.
1. Click on the device
that is to be adjusted.
2. Click on Move Selected.