CommScope ATC300-2000 - Manual (Page 28)

Section 1–System Description ATC300-1000/2000 Teletilt ® RET System
1-12 August 2014 Bulletin 639544 • Revision L
1.6 Low Voltage Cable Assemblies
(AISG Compliant RET Control Cabling)
ATCB-B01-xxx series RET control cabling is used to provide data and power from the controller to
the first junction box or device, and then (if needed) between subsequent junction boxes and devices.
See Figure 1-15. See Table 1-2 for ordering information.
Features/benefits include:
• Configured in compliance to the AISG stan-
dards.
• Several lengths available ranging from 50cm to
60m terminated with male and female connec-
tors.
• Provides shielding for lightning protection;
grounding is recommended at the tower
base, top, and at 60m intervals (Andrew
ATGK-COMP Grounding Kit). An ATGK
-CABLE grounding clamp kit is recommend-
ed for use on RET cable runs over 60m.
The main control cable feeding to the tower struc-
ture should be secured at 2m intervals and 1m
from either end using cable ties (Andrew 40417),
hangers (Andrew 68MCLICK), or similar fasteners.
Control cabling feeding between junction boxes and
actuators should be secured every 0.5 m to avoid
excessive wind vibration.
Figure 1-15. ATCB-B01 Series
Control Cable.
Part Number Description
Cables
ATCB-B01-C50 1.6 ft. (0.5m) AISG Cable
ATCB-B01-R50 1.6 ft. (0.5m) AISG Cable with
Right Angle Connector
ATCB-B01-001 3.3 ft. (1m) AISG Cable
ATCB-B01-002 6.6 ft. (2m) AISG Cable
ATCB-B01-003 9.8 ft. (3m) AISG Cable
ATCB-B01-004 13.1 ft. (4m) AISG Cable
ATCB-B01-005 16.4 ft. (5m) AISG Cable
ATCB-B01-006 19.7 ft. (6m) AISG Cable
ATCB-B01-009 29.5 ft. (9m) AISG Cable
ATCB-B01-010 32.8 ft. (10m) AISG Cable
ATCB-B01-015 49.2 ft. (15m) AISG Cable
ATCB-B01-020 65.6 ft. (20m) AISG Cable
ATCB-B01-030 98.4 ft. (30m) AISG Cable
ATCB-B01-040 131.2 ft. (40m) AISG Cable
ATCB-B01-050 164 ft. (50m) AISG Cable
ATCB-B01-060 196.9 ft. (60m) AISG Cable
Table 1-2. RET Control Cabling.