MacDon M155 Operators Manual - Manual (Page 97)

OPERATOR’S STATION
Display (lower or upper line) Description
LOAD|■■■■| | #### Bar graph representing hydraulic operating pressure. Full
scale is pre-programmed overload pressure (2500–5000
psi). If sensor disabled, LOAD does not display
9 .
### °C or F HYD OIL TEMP
### °C or F HYD TEMP Hydraulic oil temperature.
Sensor Disabled. TEMP and SENSOR alternate at
1 second intervals.
##.# VOLTS Engine electrical system operating voltage.
SCROLL
SUB-MENU (Lower Line Only)
#### DISC RPM
##.# HEADER HEIGHT
LOAD|■■■■|■■■■| #### Displays sub-menu after 2–3 seconds. Press SELECT to
cancel. Scroll through sub-menu display with CDM switch.
Miscellaneous Operational Information
Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (upper line) Description
HEADER DISENGAGED Header drive is disengaged.
##.# FOOT DISK
AUGER or DRAPER will appear in place of DISK,
depending on type of header attached.
IN PARK GSL in N-DETENT position.
< LEFT TURN ■
Indicates left turn when left arrow is pressed on CDM.
Engine-forward mode only
10
.
■ RIGHT TURN >
Indicates right turn when right arrow is pressed on CDM.
Engine forward mode only
11
■ HAZARD ■
Indicates hazard warning lights are on when hazard button
is pressed on CDM.
HEADER REVERSE Header drive running in reverse.
HEADER ENGAGED Header drive engaged.
ROAD GEAR
With HIGH RANGE selected on Console switch.
Engine-forward only
11
9. The LOAD sensor to monitor knife/conditioner circuit pressure is optional-installed. To monitor reel/auger circuit pressure,
relocate sensor as per Form MD #169031, which is available through your Dealer.
10. If road light kit is not installed, CDM will display E135 LEFT STOP LAMP as a malfunction in CAB-FORWARD mode.
11. If road light kit is not installed, CDM will display E134 RIGHT STOP LAMP as a malfunction in CAB-FORWARD mode.
169883
81
Revision A