MacDon M155 Operators Manual User Manual

Page 176

11. Engage safety props on both lift cylinders as follows:

a. Stop engine and remove key from ignition.

b. Pull lever (A) and rotate toward header to release

and lower the safety prop (B) onto cylinder.

c. Repeat for the opposite lift cylinder.

Figure 4.105: Cylinder Stop

12. Install pin (B) through the header leg, (engaging

U-bracket in lift linkage) on both sides and secure with
a hairpin (A).

13. Raise header stand (D) to storage position by pulling

spring pin (C) and lifting stand into uppermost position.
Release spring pin (C).

Figure 4.106: Header Leg

169883

160

Revision A