MacDon M155 Operators Manual - Manual (Page 288)

MAINTENANCE AND SERVICING
4. Remove the nut and bolt that secures the link (A) to the
frame. Swing link (A) out of the way.
5. Pull the front (cab-forward) end of platform away from
frame while moving it towards the walking beam. Aft
corner (B) of platform should project slightly into engine
bay when optimum opening is reached.
CAUTION
Do NOT stand on the platform in the unlocked
position. It is unstable and may result in a fall.
Figure 5.21: Platforms
5.5.4 Closing Platforms (Major Service Position)
CAUTION
Do NOT stand on the platform in the unlocked position. It is unstable and may result in a fall.
CAUTION
Do NOT stand on the platform in the unlocked
position. It is unstable and may result in a fall.
1. Swing link (A) all the way forward.
2. Push the front (cab-forward) end of platform towards
the frame while moving the platform forward
(cab-forward).
3. Position link (A) on bracket and install bolt and nut.
Tighten enough so that link can still swivel on bracket.
Figure 5.22: Platforms
4. Move platform (B) forward (cab-forward) until it stops
and latch (A) engages.
5. Close the hood. Refer to 5.4.2 Closing Hood (Lower
Position), page 267 .
Figure 5.23: Platform Latch
169883
272
Revision A