MacDon M155 Operators Manual - Manual (Page 249)

OPERATION
Setting Draper Minimum Speed
Figure 4.286: Operator Console
A - Display B - Header Index C - Draper Fast
D - Draper Slow E - Display Selector
IMPORTANT:
Windrower can be moving, but must be LESS THAN minimum reel speed.
Set DRAPER MINIMUM SPEED as follows:
1. Engage header.
2. Set HEADER INDEX (B) switch to ON.
3. Press DISPLAY SELECTOR (E) for DRAPER MIN.
4. On cab display module (CDM) press SLOW (D) until beep is heard.
5. Display (A) shows ##.## DRAPER MIN 15 .
15. DISPLAY will flash ##.# MIN CONV (MPH or KPH) to prompt you to change the minimum set point, or increase ground
speed if Ground Speed Plus Index is less than the Minimum Draper Speed Set Point.
169883
233
Revision A