Changing wheel drive lubricant, Servicing drive wheel, Danger – MacDon M155 Operators Manual User Manual
Page 389: Caution
Changing Wheel Drive Lubricant
The wheel drive lubricant should be changed after the first 50 hours and then in accordance with the maintenance
schedule. Change the lubricant when it is warm.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
1. Park windrower on level ground and position
windrower so drain plug (B) is at the lowest point.
2. Shut
down
the
windrower
and
remove
key
from ignition.
3. Place a large enough container (about 2 quarts
[2 liters]) under the lower drain plug (B).
4. Remove plugs (A) and (B), and drain lubricant
into container.
Figure 5.212: Wheel Drive
5. After the lubricant has drained completely, position the
windrower so that ports (A) and (B) on wheel are level
with the center of the hub (C) as shown.
6. Add lubricant. Refer to
.
CAUTION
Dispose oil in a manner that is in compliance with the
local rules and regulations.
Figure 5.213: Wheel Drive
Servicing Drive Wheel
To service a drive wheel, refer to the following procedures:
•
•
Removing Drive Wheel, page 375
•
Installing Drive Wheel, page 375
•
Lowering Drive Wheel, page 376
169883
373
Revision A