10safety signs, 1installing safety decals, Safety signs – MacDon M155 Operators Manual User Manual

Page 28: Installing safety decals, 10 safety signs, 1 installing safety decals

1.10

Safety Signs

• Keep safety signs clean and legible at all times.

• Replace

safety

signs

that

are

missing

become illegible.

• If original parts on which a safety sign was installed are

replaced, be sure the repair part also bears the current
safety sign.

• Safety

signs

are

available

from

your

Dealer

Parts Department.

Figure 1.19: Operator’s Manual Decal

1.10.1

Installing Safety Decals

To install a safety decal, follow these steps:

1. Be sure the installation area is clean and dry.

2. Decide on the exact location before you remove the decal backing paper.

3. Remove the smaller portion of the split backing paper.

4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is applied.

5. Small air pockets can be smoothed out or pricked with a pin.

169883

Revision A