MacDon M155 Operators Manual - Manual (Page 195)

OPERATION
10. Disconnect reel hydraulics (A) from header and
store on bracket at windrower left cab-forward side.
Refer to the draper header operator’s manual for
further information.
Figure 4.154: Reel Hydraulics
11. Loosen nut (A) and rotate barrel (B) to relieve load
on link.
12. Remove cotter pin on clevis pin (D) and remove the pin
(C) to disconnect from windrower. Reinstall clevis pin
(C) in header.
13. Tighten nut (A) against barrel. A slight tap with a
hammer is sufficient.
Figure 4.155: Mechanical Center-Link
14. Reinstall pin (A) into header leg and secure with a
hairpin (B).
Figure 4.156: Header Leg
169883
179
Revision A