MacDon M155 Operators Manual - Manual (Page 399)

MAINTENANCE AND SERVICING
CAUTION
Carefully follow safety messages given in 1 Safety, page 1 .
Break-In Inspections
Break-in Inspections
Hours Item Check
1 Drive wheel nuts
Torque: 375 ft·lbf (510 N·m) dry
Repeat checks at one hour intervals until
torque stabilizes at two consecutive checks
A/C compressor belt Tension.
Caster wheel nuts Torque: 120 ft·lbf (163 N·m)
Caster wheel anti-shimmy dampener bolts
Inboard bolt torque: 100 ft·lbf (135 N·m)
Outboard bolt torque: 85 ft·lbf (115 N·m)
5
Walking beam width adjustment bolts Torque: 330 ft·lbf (448 N·m)
Walking beam width adjustment bolts Torque: 330 ft·lbf (448 N·m)
10
Neutral Dealer adjusted
Hose clamps: air intake / radiator / heater /
hydraulic
Hand-tighten unless otherwise noted
Walking beam width adjustment bolts Torque: 330 ft·lbf (448 N·m)
Caster wheel anti-shimmy dampener bolts
Inboard bolt torque: 100 ft·lbf (135 N·m)
Outboard bolt torque: 85 ft·lbf (115 N·m)
Drive wheel lubricant
Main gearbox oil
Charge system oil filter
50
Manifold oil filter
Change
169883
383
Revision A