MacDon M155 Operators Manual - Manual (Page 143)

OPERATION
Attach center-link as follows:
13. To unlock the center-link, pull up on latch (A), and
position latch into notch (B) on top of hook.
14. Lift center-link off header pin.
NOTE: If center-link self-alignment kit is installed,
start engine and raise center-link with the
REEL UP switch on the ground speed
lever (GSL).
15. Slowly back windrower away from header, shut engine
OFF, and remove key from ignition.
Figure 4.43: Hydraulic Link
Mechanical Link
16. If using a mechanical link, disconnect the center-link as
follows:
a. Loosen nut (A), and rotate barrel (B) to relieve load
on link.
b. Remove cotter pin (D) on pin (C), and remove
pin to disconnect from windrower. Reinstall pin
in header.
Figure 4.44: Mechanical Link
A - Nut B - Barrel
C - Pin D - Cotter Pin
Attaching Header Transport Hitch to Header
Attach header transport hitch to header as follows:
1. Position end (A) of the aft section onto front wheel
hook (B).
2. Push down until latch (C) captures the end (A).
3. Secure latch (C) with clevis pin (D).
Figure 4.45: Transport Hitch
169883
127
Revision A