MacDon M155 Operators Manual - Manual (Page 178)

OPERATION
19. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the draper header
operator’s manual.
Figure 4.110: Header Drive Hoses and Harness
20. Connect reel hydraulics (A) at right-hand side
of windrower. Refer to the draper header
operator’s manual.
Figure 4.111: Reel Hydraulics
Attaching a D-Series Header: Hydraulic Center-Link without Self-Alignment
NOTE: This topic assumes that draper header boots have already been attached to the windrower lift
linkage. If that is not the case, refer to
4.6.2 Attaching Header Boots, page 228 .
To attach a D-Series header to a windrower equipped with a hydraulic center-link without the self-alignment kit, follow
these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
169883
162
Revision A