MacDon M155 Operators Manual - Manual (Page 167)

OPERATION
Programming Return to Cut Feature
Figure 4.89: Operator Console
A - Return to Cut B - Header Up C - Header Down D - Display
E - Header Tilt Up F - Header Tilt Down
Program the RETURN TO CUT feature as follows:
IMPORTANT:
The windrower must be running with the header engaged.
1. Set RETURN TO CUT switch (A) to OFF (indicator light is OFF).
2. Adjust the header to the desired cutting height with the HEADER UP (B) or HEADER DOWN (C) switches on
the ground speed lever (GSL). The cab display module (CDM) displays between 00.0 and 10.0 at (D).
3. Adjust the header angle with the HEADER TILT UP (E) or HEADER TILT DOWN (F) switches on the GSL. CDM
displays between 00.0 and 10.0. This step is not required if height only has been preselected.
4. Press the RETURN TO CUT switch (A) on the CDM. The indicator light will illuminate and the settings are now
programmed into the windrower control module (WCM).
169883
151
Revision A