MacDon M155 Operators Manual - Manual (Page 220)

OPERATION
4.5.5 Attaching an R-Series Header
M155 Self-Propelled Windrower
The M155 Self-propelled windrower can operate ONLY
13-foot R80 and R85 Rotary Disc Headers. These headers
are shipped without the motor and hoses installed, and
the installation of a separate motor and hose bundle is
necessary. A Hydraulic Valve kit is also needed to operate
the header.
If necessary, obtain the following kits from your MacDon
Dealer and install them in accordance with the instructions
supplied with the kits.
Kit Description Kit
Number
Hydraulic Drive kit B5510
Hydraulic Valve kit B4657
Refer to the procedure that is appropriate for the center-link
installed on the windrower:
• Attaching an R-Series Header: Hydraulic Center-Link
with Optional Self-Alignment, page 204
• Attaching an R-Series Header: Hydraulic Center-Link
without Self-Alignment, page 210
• Attaching an R-Series Header: Mechanical
Center-Link, page 215
Figure 4.219: M155 Hydraulic Drive Kit
(MD #B5510)
Attaching an R-Series Header: Hydraulic Center-Link with Optional Self-Alignment
To attach an R-Series header to a windrower equipped with a hydraulic center-link and optional self-alignment,
follow these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
169883
204
Revision A