7operating with an a-series header, 1auger speed, Auger speed on a30-d headers – MacDon M155 Operators Manual User Manual

Page 256: Auger speed on a40-d headers, Operating with an a-series header, Auger speed, 7 operating with an a-series header, 1 auger speed, Caution

4.7

Operating with an A-Series Header

The M155 is factory-equipped to run an A-Series Auger Header.

4.7.1

Auger Speed

Auger Speed on A30-D Headers

On A30–D Auger Headers, the auger speed is fixed to the knife speed. The auger speed is NOT monitored
and cannot be displayed.

Auger Speed on A40-D Headers

Figure 4.293: Operator Console

A - Display

B - Header Index Switch

C - Auger Fast

D - Auger Slow

E - Display Selector

D - Auger Slow

CAUTION

Check to be sure all bystanders have cleared the area.

Change auger speed as follows:

1. Engage header.

2. Set HEADER INDEX switch (B) to OFF

169883

240

Revision A