Maintaining fuel filters, Removing primary fuel filter, Danger – MacDon M155 Operators Manual User Manual
Page 320
4. Locate filter (A) on vent line against hydraulic
oil reservoir.
5. Release hose tension clamps (B) and slide away from
filter. Pull hoses off filter.
6. Position new filter through hole in frame and attach top
hose onto filter. IN marking should face down.
NOTE:
If filter has an arrow instead of an IN marking,
arrow should point up.
7. Attach lower hose to filter and secure both hoses with
tension clamps (B).
8. Close hood. Refer to
9. Close the maintenance platform. Refer to
Platforms (Standard Position), page 270
Figure 5.81: Fuel System
Maintaining Fuel Filters
The windrower fuel system is equipped with primary (A)
and secondary (B) screw-on cartridge type filters. The
primary filter (A) is equipped with a separator that
separates sediment and water from the fuel.
NOTE:
Bottom part of image was made transparent to
show the primary filter (A).
Figure 5.82: Fuel System Filters
Refer to the following procedures:
•
Removing Primary Fuel Filter, page 304
•
Installing Primary Fuel Filter, page 305
•
Removing Secondary Fuel Filter, page 306
•
Installing Secondary Fuel Filter, page 306
Removing Primary Fuel Filter
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Stop the engine and remove the key.
2. Open the hood. Refer to
169883
304
Revision A