Engine oil, Checking engine oil level, Checking engine – MacDon M155 Operators Manual User Manual
Page 309
IMPORTANT:
BATTERY IS NEGATIVE GROUNDED. Always
connect starter cable to the positive (+) terminal
of battery and battery ground cable to negative (-)
terminal of battery. Reversed polarity in battery
or alternator may result in permanent damage to
electrical system.
10. Attach negative (black) cables (B) to negative posts
on batteries, and tighten clamps. Then attach positive
(red) cables (A) to positive post on batteries and
tighten clamps.
11. Position plastic covers onto clamps.
12. Close the hood. Refer to
.
13. Close platform.
Refer to
Figure 5.61: Battery Terminal Location
Engine Oil
Checking Engine Oil Level
Check engine oil level frequently and watch for any signs of leakage.
To check the engine oil level, follow these steps:
NOTE: During the break-in period, a higher than usual oil
consumption should be considered normal.
1. Open the hood to the lowest position. Refer to
Opening Hood (Lower Position), page 266
2. Operate the engine at low idle, and check for leaks at
the filter and drain plug.
3. Stop the engine and remove the key.
Wait about
5 minutes.
169883
293
Revision A