MacDon M155 Operators Manual - Manual (Page 152)

OPERATION
10. Check for worn components and repair. Tighten loose hardware and replace any missing hardware. Refer to
5.2 Torque Specifications, page 250 .
11. Check for broken components and order replacements from your Dealer. Attention to these items right away
will save time and effort at beginning of next season.
12. Add approved rust inhibitor to the engine oil in accordance with the manufacturer’s instructions. Run engine to
operating temperature to mix inhibitor with oil, unless otherwise specified.
13. To prevent condensation, fill hydraulic oil reservoir to filler neck with approved hydraulic system oil. Refer to
Checking and Filling Hydraulic Oil, page 360 .
14. Test engine coolant antifreeze concentration to ensure it is sufficient to protect engine against lowest
expected temperature.
169883
136
Revision A