Driving in reverse in cab-forward mode, Caution, Warning – MacDon M155 Operators Manual User Manual
Page 131
CAUTION
Operate both steering wheel and ground speed lever slowly for familiarization.
Avoid the common
tendency of new Operators to oversteer.
IMPORTANT:
The windrower can be equipped with an automatic steering system for use in the field. An
automated steering system is available as an option and can be installed by a MacDon Dealer.
The GSL has been pre-wired at the factory with a switch. Also refer to
Driving in Reverse in Cab-Forward Mode
WARNING
Back up slowly. Steering is opposite to normal when reversing. Hold steering wheel at the bottom and
turn wheel in direction you want the rear (cab-forward) of the machine to travel.
1. Move speed range switch (A) to L.
2. Move throttle lever (B) to a mid-range position.
NOTE: Reversing in low speed range and at
reduced engine speed is recommended
since steering will be less sensitive than
at higher speed settings.
CAUTION
Check again to be sure all bystanders have cleared
the area.
3. Move the ground speed lever (GSL) rearward to
desired speed.
Figure 4.18: Operator’s Console
4. Steer as shown.
Figure 4.19: Cab-Forward Mode
169883
115
Revision A