MacDon M155 Operators Manual User Manual

Page 299

5. Adjust switch (A) as follows:

a. Loosen nuts (B) and rotate switch on support

sufficiently so that GSL will contact switch lever (C)
and push in the plunger (D).

b. Tighten nuts (B).

Figure 5.41: Switch Lever

6. If necessary, replace switch as follows

a. Disconnect wiring harness (A) at connector.

b. Remove nuts and screws (B) and remove

switch (C).

c. Install new switch (C) on support and secure with

nuts and screws (B).

d. Connect harness (A) to console wiring.

Figure 5.42: GSL Switch Lever

7. Position switch support plate (B) inside console and

secure with rubber nuts (A).

NOTE: For clarity, console in the image was made

transparent to show the switch support plate (B).

8. Check operation of switch.

Figure 5.43: Console (Transparent)

169883

283

Revision A