MacDon M155 Operators Manual - Manual (Page 246)

OPERATION
Figure 4.284: Operator Console
A - Display B - Header Index C - Fast
D - Slow E - Display Selector
IMPORTANT:
Windrower can be moving, but must be less than minimum reel speed.
1. Set the MINIMUM REEL SPEED as follows:
a. Engage header.
b. Set HEADER INDEX switch (B) to ON.
c. On ground speed lever (GSL), press DISPLAY SELECTOR (E) to display ##.## MIN REEL or press FAST (C)
or SLOW (D) switch.
##.## = RPM or MPH or KPH
14 .
d. Press FAST (C) or SLOW (D) until desired minimum reel speed is displayed.
NOTE: The reel will continue operating at the Minimum Reel Speed setting when ground speed drops below this
value. DISPLAY (A) will flash ##.## MIN REEL (RPM or MPH or KPH) to prompt you to change the minimum
set-point or increase ground speed if Ground Speed Plus Index is LESS THAN the Minimum Reel Speed
Set-Point.
2. Set the REEL INDEX as follows:
a. Set HEADER INDEX (B) switch to ON.
b. On GSL press DISPLAY SELECTOR (E) to display ##.## ##.# REEL IND or press FAST (C) or SLOW (D)
switch.
##.## = RPM or MPH or KPH
14 , ##.# = 0.0 to 9.9.
c. Press FAST (C) or SLOW (D) until desired reel index is displayed.
14. As per settings in CDM programming
169883
230
Revision A