MacDon M155 Operators Manual - Manual (Page 219)

OPERATION
9. Loosen nut (A) and rotate barrel (B) to relieve load
on link.
10. Remove cotter pin (D) on clevis pin (C) and remove pin
to disconnect from header.
11. Reinstall clevis pin in header.
Figure 4.216: Mechanical Center-Link
12. Disconnect header drive hydraulics (A) and
electrical harness (B). Refer to the auger header
operator’s manual.
13. Slowly back windrower away from header.
Figure 4.217: Header Drive Hydraulics
14. Reinstall clevis pin (B) and secure with hairpin (A) in
header boot (C).
15. Repeat for the opposite side.
Figure 4.218: Header Boot
169883
203
Revision A