MacDon M155 Operators Manual - Manual (Page 218)

OPERATION
6. Lower the header stand (A) by pulling clevis pin (B),
inverting stand, and relocating on bracket. Reinsert
clevis pin (B) and secure with hairpin.
Figure 4.213: Header Stands
7. Remove clevis pin from linkage (A) to disengage float
springs and insert in storage hole (B). Secure with
lynch pin. Repeat for opposite linkage.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to windrower, ensure that float engagement
pin is installed in storage location (B) and NOT
installed at hole location (A).
Figure 4.214: Header Lift Linkage
8. To disengage safety props and for storage, turn
lever (A) away from header to raise safety prop
until lever locks into vertical position.
Repeat for
opposite cylinder.
Figure 4.215: Safety Prop
169883
202
Revision A