MacDon M155 Operators Manual - Manual (Page 310)

MAINTENANCE AND SERVICING
4. Remove dipstick (B) by turning it counterclockwise
to unlock.
5. Wipe clean, reinsert in engine, and then remove.
Figure 5.62: Engine Oil Level
6. Oil level should be between LOW and HIGH. If level is
below LOW mark, 2 US quarts (1.9 liters) will raise the
level from LOW to HIGH.
NOTE: If you need to add oil, refer to Adding Engine Oil,
page 295 .
7. Replace dipstick and turn it clockwise to lock.
8. Close the hood. Refer to 5.4.4 Closing Hood (Highest
Position), page 268 .
Figure 5.63: Engine Oil Level
Changing Engine Oil
Refer to the following procedures:
• Checking Engine Oil Level, page 293
• Draining Engine Oil, page 294
• Replacing Engine Oil Filter, page 295
• Adding Engine Oil, page 295
Draining Engine Oil
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
NOTE: The engine should be warm prior to changing the oil.
1. Stop the engine and remove the key.
2. Place a drain pan with a capacity of about 6 US gallons
(24 liters) under the engine oil drain.
169883
294
Revision A