MacDon M155 Operators Manual - Manual (Page 148)

OPERATION
3. Disconnect wiring connector (A) at front wheel.
Figure 4.58: Header Transport Wheel
4. Remove clevis pin (D).
5. Push latch (C) and lift tow-bar (A) from hook. Release
latch and replace clevis pin.
6. Unhook tow-bar from weight box.
Figure 4.59: Header Transport Wheel
CAUTION
Check to be sure all bystanders have cleared the area.
7. Start engine and lower lift arms until rear of lift arms
floats up and away from the lift arm mechanism.
8. Stop engine and remove key from ignition.
9. Remove temporary lift pins (A) from weight box and
install pins (F) into holes at rear of lift arms.
10. Start engine and fully raise lift arms. Stop engine and
remove key from ignition.
11. Engage lift cylinder safety props. (Refer to 4.4.1
Header Safety Props, page 137 .) Figure 4.60: Lift Arms
169883
132
Revision A