MacDon M155 Operators Manual - Manual (Page 322)

MAINTENANCE AND SERVICING
1. Screw the new filter (A) onto the filter mount until the
gasket contacts the filter head.
2. Reconnect water in fuel (WIF) sensor (B).
3. Tighten the filter an additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install the filter.
Overtightening can damage the gasket and filter.
Figure 5.86: Fuel System
Removing Secondary Fuel Filter
1. Clean around the secondary filter head (A).
2. Place a container under the filter to catch spilled fluid.
3. Remove filter (B) with a filter wrench.
4. Clean gasket mating surface.
Figure 5.87: Fuel System
Installing Secondary Fuel Filter
IMPORTANT:
Do NOT prefill filter with fuel. Prefilling can contaminate the fuel system.
NOTE: If replacing filter, refer to Filter Part Numbers, page 264 .
169883
306
Revision A