Return filter, Removing return filter, Installing return filter – MacDon M155 Operators Manual User Manual

Page 380

Return Filter

The return filter filters the oil in the header drive systems and should be changed after the first 50 hours and
then at 500 hour intervals.

To change the return filter, refer to the following procedures:

•

•

Removing Return Filter

1. Stop the engine and remove the key.

2. Clean around head of the filter (A).

3. Place a container beneath the filter (A) to collect any

oil that may leak out.

4. Unscrew filter (A) with a filter wrench.

5. Dispose of used oil and filter in accordance with local

environmental legislation.

Figure 5.199: Hydraulic System

NOTE:

Image showing filter head removed to show
component clarity.

6. Remove gasket (C) from groove (B) in filter head (A).

Figure 5.200: Hydraulic System

Installing Return Filter

NOTE:

For filter specifications, refer to

169883

364

Revision A