MacDon M155 Operators Manual - Manual (Page 130)

OPERATION
Driving Forward in Cab-Forward Mode
WARNING
Do NOT drive windrower on road in cab-forward
configuration, unless it is equipped with the proper
lighting and markings for cab-forward road travel.
Operator’s station must be facing away from the engine. If
necessary, swivel operator’s seat to cab-forward position
as follows:
Figure 4.15: Cab-Forward Mode
1. Place ground speed lever (GSL) (A) in N-DETENT.
Engine can be running.
IMPORTANT:
If GSL is NOT in N-DETENT, damage to
the GSL cable may result when swivelling
operator’s station.
2. Pull up on knob (B) and hold to release latch (C) at
base of steering column.
3. Turn steering wheel counterclockwise to pivot
operator’s station clockwise 180° until pin engages
latch to secure operator’s station in new position.
4. Ensure seat belt is fastened.
5. Start engine if not running. Refer to Starting the
Engine, page 106 .
Figure 4.16: Operator Console
6. There are two cab-forward speed ranges. Set
ground speed range switch (A) to either H (0–16 mph
[25.7 km/h]), or L (0–11 mph [17.7 km/h]).
7. Slowly push throttle (B) to full forward (operating
speed). cab display module (CDM) should display
2320–2350 rpm at (C).
CAUTION
Check again to be sure all bystanders have cleared
the area.
8. Move the GSL (E) out of N-DETENT and slowly forward
to desired speed which will be displayed at (D).
Figure 4.17: Operator Console
169883
114
Revision A