MacDon M155 Operators Manual - Manual (Page 359)

MAINTENANCE AND SERVICING
Adjusting HID Auxiliary Lights (if Installed)
If installed, HID auxiliary lights are best adjusted with the machine in the field (or equivalent) to suit
Operator preference.
1. Shut down engine and remove key. Turn lights ON.
2. Loosen bolt (A) and nut (B) (located inside light /
mirror support).
3. Position light to desired position.
4. Tighten bolt (A) and nut (B).
Figure 5.157: HID Auxiliary Lights
Replacing HID Lamp (if Installed)
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Shut down engine and remove key. Turn lights OFF.
NOTE: Hold onto the handholds on the cab front corners
and stand on the header anti-slip strips, or stand
on the maintenance platform when accessing the
HID auxiliary lights.
2. Disconnect lamp connector (A) from electrical
harness (B).
Figure 5.158: HID Auxiliary Light Harness
169883
343
Revision A