Cleaning return air cleaner – MacDon M155 Operators Manual User Manual

Page 303

2. Separate the filter (B) from the cover (A).

3. Clean or replace filter. If cleaning filter, see

4. Assemble the cleaner (B) and cover (A), and position

on cab wall over opening.

Figure 5.50: Return Air Filter

5. Secure filter assembly (B) to cab wall with knobs (A).

Figure 5.51: Return Air Filter

Cleaning Return Air Cleaner

Clean the electrostatic filter as follows:

1. Mix a solution of warm water and detergent in a

suitable container so that the filter (B) can soak for a
few minutes.

2. Agitate to flush out the dirt.

3. Rinse with clean water,

and then dry with

compressed air.

4. Inspect filter for damage, separation, and holes.

Replace if damaged.

Figure 5.52: Return Air Filter

169883

287

Revision A