MacDon M155 Operators Manual - Manual (Page 201)

OPERATION
CAUTION
Check to be sure all bystanders have cleared the area.
18. Start engine and activate HEADER DOWN switch (A)
on GSL to lower header fully. Stop engine and
remove key.
Figure 4.170: GSL
19. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the auger header
operator’s manual.
Figure 4.171: Header Drive Hoses and Harness
Attaching an A-Series Header: Hydraulic Center-Link without Self-Alignment
To attach an A-Series header to a windrower equipped with a hydraulic center-link without the self-alignment kit,
follow these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
169883
185
Revision A