MacDon M155 Operators Manual - Manual (Page 63)

OPERATOR’S STATION
3.7 Lighting
The field and road light switches are located on a panel in
the cab headliner.
The lighting is dependent upon the position of the
operator’s station,
that is, cab-forward mode or
engine-forward mode. The position of the operator’s
station automatically determines the lighting.
The hazard lights will be automatically activated when
certain conditions are met.
The windrower must be
cab-forward, medium range, brake off, and header off.
The work lights will not turn on in certain instances. If
the windrower is engine-forward or if the windrower is
cab-forward, out of park, medium range, and header off.
IMPORTANT:
Red and amber reflector tape is applied
to be visible in both engine-forward and
cab-forward modes.
Figure 3.16: Roof Liner Console
A - Field or Road Lights B - Low or High Beams
C - Beacon (If Equipped)
3.7.1 Cab-Forward Lighting: Field
The following lights are on when the light switch is in FIELD
position with the windrower in cab-forward mode:
• Field lights in cab roof (front and rear)
• Swath lights in hood
• HID lights (if installed) on mirror supports
Figure 3.17: Field Light Switch
169883
47
Revision A