MacDon M155 Operators Manual User Manual
Page 101
Display (A)
Flashing
Alarm Tone
Description
NO OPERATOR
Continuous Tone.
Operator Not Detected in Seat
with Header Engaged or out of
N-DETENT. Engine Shutdown
after 5 Seconds.
NO OPERATOR ENGINE
SHUT DOWN
Continuous Tone.
Engine Shutdown When Operator
not Detected in Seat with Machine
Moving Under 3 mph (4.8 km/h).
NOT IN PARK
X
Short Beep with Each Flash.
GSL or Interlock Switches Not
Closed with Key ON / Engine OFF.
PLACE GSL INTO “N”
Beeps at 2 per Second until
Corrected.
GSL or Interlock Switches Not
Closed with Key ON / Engine OFF.
SLOW DOWN
X
Short Beep with Each Flash.
Ground Speed is Greater Than
or Equal to 25 mph (40 km/h).
Operator Should Pull Back on the
GSL to Reduce Ground Speed.
TRANS OIL PRESS
X
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Transmission Charge Oil
Pressure.
TRANS OIL TEMP
X
Ongoing Intermittent Moderate
Tone Until Temperature Is
Below Acceptable Level.
Transmission Oil Temperature
Above 221°F (106°C) .
##.# LOW VOLTS
X
Single Loud Tone for 10
Seconds.
Voltage Below 11.5.
##.# HIGH VOLTS
X
Single Loud Tone for 10
Seconds.
Voltage Above 15.5.
169883
85
Revision A