Lenze DDS v2.3 - Manual (Page 175)

Drive PLC Developer Studio
Editors
7-53
l
DDS EN 2.3
7.7.12.6 To the beginning
Icon: - Menu: ExtrasWOrderWTo the beginning Keyboard: -
Use this command to bring all selected elements to the beginning of the sequential function chart
in the CFC editor.
•
The sequence among the selected elements remains unchanged.
•
The sequence among the other elements also remains unchanged.
7.7.12.7 To the end
Icon: - Menu: ExtrasWOrderWTo the end Keyboard: -
Use this command to send all selected elements to the end of the sequential function chart in the
CFC editor.
•
The sequence among the selected elements remains unchanged.
•
The sequence among the other elements also remains unchanged.
7.7.12.8 Create macro
Icon: Menu: ExtrasWCreate Macro Keyboard: +
Use this command to group several boxes into one block that can then be named as a macro.
•
Macros are duplicated with Copy and Insert. Each copy represents a separate macro that
can be freely named. Macros are no references.
•
Connections separated by macros create in or out pins at the macro. Connections to inputs
create an in pin, for example. The default name appears in the format In- next to the
created in pin, and as Out- for outputs.
•
Any connections affected that featured connectors prior to macro creation, are assigned the
connector the macro PIN.
•
Initially, any macro is given the default name MACRO. That can be changed.
Three boxes and one input have been selected for the example.
The following macro is created with menu command Extras
WCreate macro. The unit can be shown
more efficiently by moving the boxes.
Show/Hide Bookmarks