INFICON XTC/3 Thin Film Deposition Controller Operating Manual - Manual (Page 133)

5 - 21
PN
07
4-
44
6-
P1
J
XTC/3 Operating Manual
5.2.2.4.3 Standard Update Film Parameters
Command:
UF
Command ID = . See “UF Command ID” column of Table 5-2 .
Film Number = 1-9 (XTC/3S ) or 1-32 (XTC/3M)
Parameter Value = |
Integer = 4 byte, low to high
Float = 4 byte, ANSII standard, single precision, low to high
Description: Type of parameter value depends on command ID,
see “DataType / Format” column of
Table 5-2 .
Response:
None (Just header and trailer)
Special Case: UF255 order> will update all film parameters for the given film, in numeric order.
NOTE: Some limitations apply as to when specific film parameters may be
updated, e.g., Hardware used by a film cannot be redefined while that film
is active. All parameters may be updated in Ready state.