NORD Drivesystems BU0200 - Manual (Page 267)

SK 200E Manual for frequency inverters
266 Subject to technical alterations BU 0200 GB-4411
7.2.2 Table of possible error messages in the I/O extension module
Error number
Error
Text in the Parameter Box
Cause
Remedy
Group Details in
P170
E1000 1000 EEPROM error EMC interference on the SPI bus
Module faulty
1030 System bus, Bus Off Check connections and cables
Ensure 24V power supply
Check Bus master.
E2000 2000 DIP changed/fault DIP switch configuration changed during operation
2001 DIP invalid config
"DIP invalid configuration"
Illegal DIP switch setting
Check DIP switch setting. Note coding of analog inputs and
outputs!
2010 A out fault
"Analog output fault" Check switching of 10V reference voltage
Short circuit of analog output
Analog output overload (max. 10mA)
Calibration error (P152)
A range error has occurred during measurement
of the correction values
The measured values could not be saved in the
EEPROM
2020 Inverter does not support
SK xU4-IOE The connected frequency inverter does not support the
IO extension.
(Fault not associated with SK 2xxE possible)