NORD Drivesystems BU0200 - Manual (Page 143)

SK 200E Manual for frequency inverters
142 Subject to technical alterations BU 0200 GB-4411
Menu structure level
Screen layout during parameterisation
If the setting of a parameter is changed, then the value flashes until it is confirmed with the OK key. In order
to retain the default settings for the parameter being edited, both VALUE keys must be pressed
simultaneously. Even in this case, the setting must be confirmed with the OK key in order for the change to
be saved.
If the change is not to be saved, then pressing one of the SELECTION keys will call up the previously stored
value and pressing a SELECTION key again will exit the parameter.
P102 PS1 3
Acceleration time
2.90 s
ONLINE FI P1 E ready
NOTE: The lower line in the display is used to display the current status of the box and the frequency
inverter being controlled.
NOTE: Some parameters (e.g. P502) have additional array levels, in which further settings can be
made. The required array level must first be selected (see parameterisation, Section 6) and
confirmed with OK. The required parameter setting can now be made.
P502 PS1 [01] 3
Master function value
Off
ONLINE FI P1 E ready
Parameter set to be edited
Parameter to be edited (No.)
Parameter to be
edited (text)
Current
ParameterBox
status
Selected con-
trol medium
Active parameter set in
control object
Status of
control object
Array level of the select-
ed parameter.
e.g. [01], [02], [03]...
Current parameter
value