NORD Drivesystems BU0200 - Manual (Page 142)

4 Display and control
BU 0200 GB-4411 Subject to technical alterations 141
Controlling the frequency inverter with the ParameterBox
The frequency inverter can only be completely controlled via the ParameterBox if the parameter >Interface<
(P509) is set to the >Control terminal or Keyboard< function (=0) (factory setting) and the inverter is not
enabled via the control terminal.
STOP
Store current frequency
as jog frequency
Set frequency = 0Hz
(press simultaneously)
Increase frequency
Change rotation direction
Decrease frequency
START
Note: If the frequency inverter is enabled in this mode, then the parameter set is used, which is
selected for this frequency inverter in the Menu >Parameterisation< ... >Basic parameters< ...
under Parameters >Parameter set<.
Attention:Following the START command, the frequency inverter may start up immediately with a pre-
programmed frequency (minimum frequency P104 or jog frequency P113).
Parameterisation with the ParameterBox
The parameterising mode is entered by selecting the group >Parameterisation< in menu level 1 of the
ParameterBox and confirming this with the OK key. The parameter level of the connected frequency inverter
is now visible.
Press simultaneously:
default settings for this
parameter
Increase parameter value
Reduce parameter value
Open menu group or
save new setting
Press simultaneously:
one level back
Increase menu group
or parameter
Reduce menu group
or parameter